1.) Installing Nextcloudpi

- get the NCP Image here:

- for Windows: ~~flash~~donwload ~~the~~and ~~image~~install tobelanaEtcher

~~ssd with balenaEtcher~~

- in settings: activate "Unsafe mode", so it also detects your hard drives

- when flashing the image to drive is successful disconect the SSD from computer and reconnect it again

- get the needed files for ssd boot from here:

- extract the files somewhere on your computer

- go into the boot folder inside the folder you just extracted

- copy over all the files that end in .elf or .dat to the boot volume of your USB drive (replacing the same-named files that already exist there)

- now connect the SSD to your Raspberry

- don't forget to connect the pi to your network (for this method i postulate a cable connetion)

- let the pi boot up; this may take some minutes

For the next step i will redirect to the offical nextcloudpi guide until my own documentation will be ready